Project : DST (Dallas Stars Tribute)

[Tech-Daddy]

Hey TAZTG!
Hot glue, by itself, would not likely hold the panel for a long period of time if you were just to put the hot glue down and them put the window on top of it. Hot glue excells with oddly shaped surfaces, not perfectly flat and smooth surfaces.

*buuuuut*

If you were to drill a small hole where you were putting the glue, and then put the glue on the back of the panel, then push the window *with the hole* over the glue (so that the glue pushes through the hole and adheres, that may make it a stronger joint.

Typically, I use double sided "super tape" for my window mounts. Is is a 3M tape... I'll get you the model on that stuff. Would recommend that more than hot glue. Super strong, and damn near permanent.

[TAZTG]

Hey TAZTG!
Hot glue, by itself, would not likely hold the panel for a long period of time if you were just to put the hot glue down and them put the window on top of it. Hot glue excells with oddly shaped surfaces, not perfectly flat and smooth surfaces.

*buuuuut*

If you were to drill a small hole where you were putting the glue, and then put the glue on the back of the panel, then push the window *with the hole* over the glue (so that the glue pushes through the hole and adheres, that may make it a stronger joint.

Typically, I use double sided "super tape" for my window mounts. Is is a 3M tape... I'll get you the model on that stuff. Would recommend that more than hot glue. Super strong, and damn near permanent.

I have been using the 3M VHB, its the strongest and was recommended by Bill.

[Tech-Daddy]

Thhaaaats tha stuff!

[bugspop1]

Haven't seen those kind of Hockey Pucks since I was a kid. My uncle worked the local hockey arena and would get us these pucks for free. Back then they called these puck, practice pucks! My uncle told us that they were for indoor non-ice practice. We did use them for just that! BTW, looks great as usual!