Hi guys hopeing someone can help
i have a sky broadband connection was 100mbps but have upgrade to 200 mbps
check connection speed and can get above 89mbps, which if a lot of people are using i can except
but i cant work out whats wrong hardware side i have a rampage formula x79 board cat 5e cable
speed link is set to auto b Register Status : Passed
EEPROM Status : Passed
FIFO Status : Passed
Interrupt Status : Passed
Loopback Test(s) : Passed
ut if i set it to 1gbps i lose connection to net? run test and
if set to 100 mbps i get this
Connection Status : Passed
Successfully pinged Gateway address 192.168.0.1
Cable Link Status : Passed
The adapter is configured to force the
speed to a low speed.
but if i set to 1gbps i get this
Connection Status : Failed
This adapter does not have link. Make
sure the cable is connected and the speed
and duplex settings are configured correctly
on the adapter and link partner.
Cable Link Status : Failed
This adapter does not have link. Make
sure the cable is connected and the speed
and duplex settings are configured correctly
if i speed test mac book its at same speed over wirless as computer so im think im not get the speed from sky? if i not would that stop my lan from switching to 1gbps connection ? hope this makes sense im confused