-
Nvidia 780i motherboard - slots 1&3 fried?
Hi all,
My system (nvidia 780i SLI motherboard, all 4 DIMMS filled with 2GB Mushkin PC2-6400) was running fine for 2.5 years, until yesterday when it shut down. On reboot, I was getting C1 errors, suggesting something about the memory was no longer happy.
From the CPU side, this motherboard identifies its DIMM slots as 0 and 2, then 1 and 3. Running Memtest, I learned:
1. Individually, all 4 memory sticks successfully pass memtest in slots 0 or 2.
2. Individually, they each fail in slots 1 or 3.
3. I can put 2 sticks into slots 0 and 2 and pass, but because that's not the correct matching slot pair, the system thinks only 2 gigs are on board. Matching pairs are 0 and 1, 2 and 3.
4. Adding a third or fourth stick into 1 and/or 3, and I'm getting the C1 error again.
After, I tweaked the memory voltage up a bit, from 1.8 to 1.95v, even upping the north bridge to 1.4v. And tuned down the timing to 5/5/5/18/2T. No change, switched it back to defaults.
So, all 4 sticks seem fine, but slots 1 and 3 (the two furthest from the cpu) are suddenly unhappy. Bad memory controller on the motherboard, then? Is there anything I can do to revive it?
And even if not, is there a way I can get the mobo to recognize both 2 gig sticks sitting in non-paired slots 0 and 2?
Thanks for any help. Cheers.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|
|