PIII700 slot 1 @ 1050 cCo stepping, Alpha cooling, Temps 26C (idle)
Abit BE6 (not BE6-II)
Crucial PC133 Cas2
Geforce2 GTS-V (just put in today)
Symptons after slowly increasing speed to 1050
1) 3DMark2001 quits half way through the benchmark and goes back to windows screen
2) 1 minute into Unreal Tournament games stops and "general protection error" or pops up
3) Blue screen comes up and says something like "memory management"
What's your guess as to my problems?
The interesting thing is that just the other day I was successfully running a GF2MMX400 at 1050 without any problems.... I thought the GTS-v was a much better card. Now I didnt put it on a stress test but I played UT for atleast 15-20 minutes without any problems with the MMX.
Note: Now the GTS does have 32mg vs the MMX's 64mb but I didnt think that would matter.
Could it be the drivers?
XP2100 oc'd to 2.2ghz
slk-800, Smartfan II
Here is what my selection looks like currently:
CAS Latency Time: 2
Leadoff Command: 3
Precharge Control: Disable
Should i change these? Even though i have CAS2 memory should I change it to 3?
Yes, you should change you cas latency to 3, because your ram is intended to work @cas 2 when it runs @133mhz and in most cases reducing the cas latency to 3 at a higher frequency then the ram default might improve stability.
[This message has been edited by bootlog (edited January 25, 2002).]
I have a junk which spits out 150 points @ 3Dmark 2k3...