Packard Bell Computer

Un4given:

You are just the information source I need. I have been given a PB system that needed a hard drive and I managed that repair. I'm going to give it to an underprivileged kid that I know. The motherboard in this system has only 2 memory slots and has a total of 24mb of ram filling these slots. I believe the CPU is a 90Mhz Pentium. Information on the case is as follows:

Model A940-TWRA
P/N 890418
L140241251+

I have a number of faster CPU's that are pentium 1's but I can't find any information on how to set the jumpers or what the motherboard will handle. I have both 133Mhz and 166Mhz cpus available. Any help you could provide would be greatly appreciated!

Unfortunately, that board only supports up to a 100MHz chip. The following are the CPU jumper settings for that board.

Code:

---


        J1J1      J1J2
75MHz    1-2      2-3
90MHz    2-3      2-3
100MHz  1-2      1-2

---

Thanks for the information. I guess I'll up the ram and leave it as a 90Mhz chip. It will work for the internet and word processing. Am I correct that the board supports EDO and will the bios support 64MB in two 32mb sticks?

The board with only 2 SIMM sockets will support memory upgrades to 72MB of RAM 2x32MB SIMMs + 8MB SMT memory.

The board only supports FP memory and will not support EDO.

Thanks for the info. I'll order a couple 32meg sticks of FP today.

Good luck, I hope everything works okay.