My MOSFETS have SUNK...

...ok, maybe not, but they have been sinked!

Heatsinked that is:
http://www.imagestation.com/picture/...f/fada4109.jpg
http://www.imagestation.com/picture/...d/fada4104.jpg
http://www.imagestation.com/picture/...1/fada40fe.jpg
I should probably have found a way to apply pressure to it though during the curing process, but too late now.:(

I noticed a significant +12v and vcore rail stabilization too.:)
As for overclocking, won't find that out until I can get some new RAM.

*edit-bah, dumb Imagstation links...*

looks purdy :cool:

how much fluctuation did you have on the core and 12v before and after?

Excellent job on the sinkage man:)

Did you cut those yourself? Man, it looks professional! I'll bet it was hard to cut those sinks that small:eek:

Quote:

---

Originally posted by thebove
how much fluctuation did you have on the core and 12v before and after?

---

I was wondering that too...

Do tell. :)

Well, all readings are measured by the Epox utility at one second intervals.

The 12v used to dance around from 11.7 to 11.9 fairly erratically-now it is almost constant at 11.9.

The vcore is set to 1.725v in the BIOS. It used to dance back and forth from 1.696 and 1.712-now it is at 1.696 99% of the time.

My 5v rail used to move around a bit more too(not as much as the others at all, however), but now is 99.99% of the time at 4.865.

So, overall, the rails are more consistent.:)

I do wish this board didn't undervolt so much though.:(

Not bad for five minutes of application, letting my neighbor cut them, and about $.25 worth of Alumina Epoxy I'd say.:D

Not sure why, but my +12v rails improves under load...:confused::)

Wish I had a multimeter...