-
i had been setting voltages in the bios so that the 2.6v setting was 3.2v so that the 2.9 setting was 3.5. that went fine, but as soon as i switched it to the 2.9 setting the computer stopped turning on... i don't know why it did it at this point because i had been up to 3.5v, but not via bios setting, just by tweaking the resistor while on default settings.
-
Maybe it was too high of a jump :|
RMAing my mobo cause one of the 3 dimm slots is pretty much dead (doesn't like anything in there), and another is flaky :|
Fun, RMAing a mobo and a vid card, and didn't even get a chance to do anything extreme to them.
