I first wanted to thank everyone for sharing their knowledge on this forum, which ultimatly helped me decide on the following system after many late nights of reading.

Epox 8RDA+ A1
XP 2100+
Kingston Hyper X 2x512mb PC3000

The problem I am having is that I can't push the memory past 168FSB. If I run out of sync, the processor has no problem at 200 FSB, so long as the memory doesn't go above 168. I have tryed every concevable combination of voltage and timing, but nothing will work.

Since I am fairly new to all of this I just wanted to know if everyone felt my memory was the problem, or perhaps I have a bad board? Should I RMA back to newegg, or exchange for PC3500 just to be safe?

BTW, it flashes C1 and beeps, and I get no screen.

Any help would be greatly appreciated.
Thanks,
Todd