Originally posted by jzinckgra
As expected, I've got 2 questions for you gurus:
1) the antec PS has a small connector to plug into the mb so that you can monitor the ps fan speed. I looked on the p4p800mb and could not find where to plug it in. I only saw to potential sites: the chassis fan connector and one labelled pwr fan. Would the pwr one be the correct one? It is a 3 pin plug coming from the ps.
2) I'm temporarily using my ati radeon 7200 video card till I get the 9800. When I installed XP last nite, naturally XP loaded a generic driver for the card. Wh en I go to install the 9800 do I need to uninstall and remove the generic driver that is being used for the 7200 1st, then load the 9800 driver or can I just install the 9800 driver over the top? Thahks again.
1) yes, I believe you can plug it into any 3 pin motherboard power connector, though if it sucks too much power you could kill that specific connector. I don't think plugging in your PSU fan to monitor its rotation speed is that necessary though.

2) You can do either one. Most people would suggest (as would I) to try your best to remove all traces of the generic and 7200 driver, THEN install the 9800, although you can just install the 9800 if you want.