How to setup a TV, PLEASE HELP!!!

[king_yip]

Ok, here's what I have: A7N8X deluxe and Leadtek Winfast A250 Ultra ViVo, and I am trying to make this to work with my crap TV(with VCR), there are only 3 cable slots for my TV, Audio(white), Video(yellow), and the regular cable plug.

Maybe the setup guide really is that bad or I am just too noobish setting up these stuff, but I got my monitor plugged in the regular monitor slot, then I used the blue ViVo cable and plugged into the middle slot. Now this cable splits two different way, Video In and Video Out.

Assuming I am not a complete idiot, I plugged the yellow cable to the Video Out slot on the ViVo cable and my yellow cable slot on my TV, all I can see is columns of black and white with the screen flickering. Then I tried plugging it to the Video In slot and played a tape, my little software from Leadtek shows a blank screen.

How am I suppose to setup this thing? Under display properties I only see one monitor, shouldn't my TV be there too? I should be able to display my desktop on both my monitor and my tv right?

PLEASE HELP!!! THANK YOU IN ADVANCE!!!

[Vengance_01]

Only need one cable. The video out. Plug that end into the yello(video in on the TV. Make sure You TV is on input mode. Under drivers then you should have the otions. You may have to enable something in the driver options

[king_yip]

Should I be able to see my TV as a monitor of choice?

[Vengance_01]

Umm you should be able to selected either one as primary/secondary. Did you enable TV display as an options. It is delfult of in the NVIEW section of the drivers.

[king_yip]

Got it! Thanks a million! I have it set up so my mouse can whatever I drag and rollover to the 2nd screen, now the final question is... can I display the same desktop I am viewing right now instead of having it act like an extended screen?

[benneke]

there is a setting in nview: cloning, enable that